Advertisement
Quick Links
Advertisement
Summary of Contents for DARTWOOD Wireless-N WiFi Extender
- Page 1 Wireless-N WiFi Extender User Manual...
- Page 2 In the Box 1 x WiFi extender 1 x LAN cable (RJ45) Page 1...
- Page 3 Introduction to Parts 1. Power indicator 4. LAN indicator 7. Reset button 2. WLAN indicator 5. WPS button 3. WPS indicator 6. LAN port Preparation • Prepare the current wireless network password for setup. • Make sure your current router works properly and supports a 2.4 GHz network.
-
Page 4: Installation
Installation Note: This device is intended to extend your wireless network coverage. It does not help to improve the speed. The network speed is limited by the original network and depends on different factors, such as signal strength, distance, obstacles, etc. 1. - Page 5 2. Search the WiFi network on your device named “wifi repeater-xxxxxx”, then connect to the extender network. If you can't find the extender, reset the extender by using a pin to press the reset button and try again. Page 4...
- Page 6 3. A login page will show up automatically. You can also manually visit the login page from the web browser via: http://192.168.11.1 or http://myrepeater.net (Note: be sure your device is connected to the extender network when logging in). Page 5...
- Page 7 4. The default login details are as follows, in all lower-case letters: User name: admin Password: admin *If you can't log in, reset the extender by using a pin to press the reset button then repeating the steps. 5. Once logged in, you will enter the configuration page as follows, click the “Repeater mode”...
- Page 8 6. Wait a moment to scan the wireless network nearby. Then, select your existing wireless network from the list and click “Scan AP” to refresh the list if you cannot find your existing WiFi network. Page 7...
- Page 9 7. Next, enter the password of your existing network and the name for the extender, then click “Save”. (Note: make sure you enter the correct password, otherwise the extender may not be able to connect to your wireless network.) Page 8...
- Page 10 8. The extender setup is complete and will reboot to the name you set. You may connect to the Extender SSID now, use the same password from the original network to log in. Page 9...
- Page 11 Relocate: Once the setup is complete, you may relocate the WiFi extender in between the wireless router and the place you will use it, in order to extend the coverage. Wait for the WLAN indicator to turn solid green, then the network is ready to use.
- Page 12 Factory reset To reset to factory settings, use a pin to press the reset button for at least 8 seconds. Wait for the WLAN indicator switch off and turn solid green again. The device will show up as “wifi repeater-xxxxxx” on the available WiFi network on your device list.
-
Page 13: Troubleshooting
Connect via WPS button WPS is a faster method to connect your extender to the WiFi network. Make sure your router supports WPS and has a button similar to the following icons. Press the button on your router and then the extender within a short period of time. -
Page 14: Specifications
I cannot load the login Your device may not be page properly. compatible, try again using another device, such as a laptop or smartphone. I cannot scan the original WiFi Make sure the extender and your network from the list. WiFi router are in range. - Page 15 Get More Support Scan the QR code below or email us at: contact@wasserstein-home.com...