Immergas HYDRO 3 V2 User Manual page 69

5
RECOMMENDATIONS -
MAINTENANCE AND REPAIRS
5.1 ADVICE FOR THE USER.
- Make sure there are no obstructions along the drain or on
the air intake.
- Make sure the earthing wire is connected properly.
- Replace the filters if necessary.
- Make sure there are no obstacles between the remote con-
trol and the indoor unit's receiver, otherwise the signal will
not reach the fan coil.
- Keep the remote control away from liquids.
- Protect the remote control from high temperatures and do
not expose it to direct sunlight.
- Do not let the receiver be exposed to direct sunlight, oth-
erwise it could malfunction.
- Keep the remote control away from equipment that could
give rise to electromagnetic interference, such as: televi-
sions, audio-video systems, electric ovens, etc.
Important note - End of the device's service life:
• At the end of its service life, the device must be taken to
a sorting centre for electrical and electronic equipment.
Do not dispose of the device with household waste, but
dispose of it in the collection centres provided, where it
can be recycled. Check your local collection service to find
out about existing waste collection centres.
Disposal of electrical appliances at non-authorised land-
fills could result in hazardous substances being dumped
into groundwater, and consequent insertion into the food
chain, with harm being caused to the health and well-being
of users.
5.2 HOUSEHOLD MAINTENANCE.
Note: before cleaning the fan coil, make sure it is unplugged.
make sure the wiring is not broken or discon-
Note:
nected.
clean the indoor unit and the remote control
Note:
with a dry cloth.
a wet cloth may be used to clean the indoor unit
Note:
if it is very dirty.
never use a wet cloth on the remote control.
Note:
do not dry the unit with chemically treated cloths
Note:
or leave them on it for a prolonged period to avoid
damaging or discolouring the surface.
do not use petrol, thinners, powder detergents
Note:
or other similar cleaning solvents as they may break
or deform the plastic surface.
Maintenance after a long downtime (e.g.: at the
•
beginning of the season).
Check and remove any object that can block the inlet
and outlet vents of the indoor and outdoor units.
Clean the filters and casings of the indoor units.
See the "Cleaning the air filter" section for more in-
formation and make sure the air filters are installed
in the same position.
Maintenance before a long downtime (e.g.: at the
•
beginning of the winter season).
To avoid the risk of breakage due to freezing, it is
advisable to drain the water from the system at the
beginning of the winter season.
Maintenance before a long downtime (e.g.: at the
•
end of the season).
Leave the indoor units working with only the fans
running for approximately half a day to dry all of the
internal parts.
Clean the filters and casings of the indoor units. See
the "Cleaning the air filter" section for more informa-
tion and make sure the air filters are installed in the
same position.
Take the batteries out of the remote control.
69