Table of Contents
Advertisement
Available languages
Available languages
INSTALLING THE CONNECTION AND DRAIN PIPES
• Drainage
- Insert the drain pipe so that it slopes slightly downwards.
In (Fig. 9) shows the proper installation and those that
are not allowed.
- When connecting the drain pipe, insulate the part con-
necting the extension with the hard plastic pipe (Fig. 10).
• Connection pipe (Fig. 11)
- Install the left and rear left pipes as shown below. Bend
the connection pipe to a height of 43 mm or less from the
wall.
- Secure the end of the connection pipe (see the tightening
procedure in the section on INSTALLING THE WATER
PIPES). When connected, cover all of the pipes with heat-
resistant material.
Do not bend the pipe
Do not insert the end
into the water pipe
1
3
Key:
1 - Hard plastic pipe
2 - Wall
3 - Drain pipe
4 - Drain pipe extension
Note: bend and position the pipe carefully.
Ensure the pipe does not protrude from the back of the
indoor unit.
Make sure the drain pipe is connected correctly.
Insulate the supply and return pipes.
Pass the drain pipe under the supply pipe and the return pipe.
In the event of supply and return piping connections coming
from the left side (looking at the split front), we recommend
using a cassette tape to split predisposition, recessed to avoid
having joints hydronic bulwarks.
9
2
4
10
46
1
2
3
5
.
.
BOTTOM VIEW
Key:
1 - Left pipe
2 - Rear left pipe
3 - Rearright pipe
4 - Right pipe
5 - Indoor unit profile
6 - Connection pipe
4
6
.
11
Advertisement
Table of Contents
