Sequence Macro - Logitech G HUB Manual

f. DELETE THIS MACRO. Click this to delete the macro. This will only appear if the Macro has been saved
previously. You will have a notification at the bottom of the screen to verify you want to delete.
5. Click the at the top to cancel the NEW MACRO editor and go back to the Assignments tab. If you have made
any changes, you will see a prompt at the bottom asking if you would like to save any changes.

SEQUENCE MACRO

1. ON PRESS. This section will control what happens immediately when you press the button/key.
2. WHILE HOLDING. The commands assigned in this section will repeat whilst the button/key is held down.
3. ON RELEASE. This section will control what happens immediately after you release the button/key.
Note: The ON PRESS and ON RELEASE which relate to the physical state of the button/key being pressed. Each of these
states can contain a macro. This should not be confused with the down-press and up-press events that happens within
that macro.
To start recording your macro, click on the + or the START NOW text. You will be given the same 6 options:
a. Record Keystrokes
b. TEXT & EMOJIS. Create a personalised text string with emojis
c. ACTION. Create an action to integrate with a Voice Application
d. LAUNCH APPLICATION. Create a shortcut to launch an application
e. SYSTEM. Select a system command
f. DELAY. Add a delay, default is 50ms but this can be changed
g. . Cancels the START NOW
48