Health O Meter 500KL Manual page 2

Hide thumbs Also See for 500KL:

This scale has been factory calibrated, and does not require calibration prior to use.

There are no requirements for calibration in the field; users should adhere to their institution's

calibration policies. If required, the scale can be calibrated. Calibration of your scale is

performed using 80 kilograms (KG) or 200 pounds (LB), according to the units of measure used

upon entering into the calibration path. THE 500KG CAN ONLY BE CALIBRATED IN

KILOGRAMS.

If Everlock

is engaged the scale can only be calibrated in the locked unit of measure.

Note: Only weights certified and traceable to national standards should be used for

calibration procedures.

1. Press and hold the UNIT and ZERO/TARE buttons at the same time, and press and

release the

buttons until "CAL" appears on the display. Release all buttons. Note: The display will

show "CAL" until the button combination is released.

2. Once the buttons are released the following message will scroll horizontally across the

screen : "– 2Ero SCALE – ". With no weight on the platform, press the ZERO/TARE

button.

3. The scale will zero and the following message will scroll horizontally across the screen:

"- PLACE 200 ON SCALE PrESS EnTEr–" (if in pounds) or "– PLACE 80 ON SCALE

PrESS EnTEr– " (if in KG). You may toggle between pounds and kilograms using the

UNIT button. If Everlock

weight measurement unit.

4. Once the proper weight is placed on the platform, press the ENTER button. The

message "– CAL –" will flash on the screen while the scale is calibrating.

If the weight is within calibration range, a four digit number will display on the

screen. Remove the weight from the scale and the scale will restart. Note: the 4

digit calibration count will stay until the weight is removed.

B. If the weight placed on the scale does not match the correct calibration

standard (200 lb or 80 kg), the following message will be displayed: "– Out OF

RANGE –". Calibration is not performed. Press CLEAR/REWEIGH button to exit

the calibration mode. The scale will restart and go through the power up

sequence to show 0.0. Power off the scale and begin the calibration process

again.

P/N UM500KL 500KG Rev 20190408_Web

button to turn on the scale. Remain pressing the UNIT and ZERO/TARE

is engaged you will only be able to calibrate in the locked

500kg 500klhb