Anker NEBULA Astro - Mini Portable Movie Projector Quick Start Guide

Charging Nebula Astro

Preparing the Remote Control

1. Slide down to open the battery compartment.
   
   
2. Insert new batteries, matching the polarity (+ / -) as indicated.
   

Powering On Astro

Press and hold the power button for 2 seconds to power on / off. When the projector is in standby mode, press the power button to turn on / off.

Adjusting the Focus

Controlling Astro

Downloading the Nebula Connect App

Download the Nebula Connect app to control the projector using a smartphone.

Wireless Screen Mirroring

Wirelessly cast movies, games, and music from your phone to Nebula Astro.

Bluetooth Speaker Mode

1. Press to switch to Bluetooth speaker mode.
2. Enable Bluetooth on your smartphone and select [Nebula-XXXXXX] as the device to be connected.

Playing Video from HDMI / USB Devices

Important Safety Instructions

• The adapter should be installed near the equipment and must be easily accessible.
• Do not use the device in an environment where the temperature is too high or too low. Never expose the device to strong sunshine or wet environments.
• The ideal temperature range for this product and its accessories is 41°F-95°F / 5°C-35°C.
• When charging, place the device in an environment with a temperature that ranges between 41°F - 77°F / 5°C- 25°C as well as good ventilation.
• Only use the charger provided by the manufacturer. Using unauthorized chargers may cause danger and violate the projector's guarantee.
• This charger is for indoor use only.
• The charger type is DST451-150300W-K with output voltage / current of DC 15V / 3A. The plug of the adapter is considered as the disconnect device. Once unplugged, the charger is considered as disconnected from the power source.

Notice

This product complies with the radio interference requirements of the European Community.

Declaration of Conformity

Hereby, Anker Innovations Limited. declares that this device is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU. For the Declaration of Conformity, visit the website: www.SeeNebula.com.

RF exposure information: The Maximum Permissible Exposure (MPE) level has been calculated based on a distance of d=20 cm between the device and the human body. To maintain compliance with RF exposure requirements, use products that maintain a 20cm distance between the device and human body.

CAUTION RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE. DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS

Wi-Fi Operating Frequency Range: 2412~2472MHz(2.4G); 5150~5250MHz, 5725~5850MHz (5G)

Wi-Fi Max Output Power: 18.97dBm(ERIP for 2.4G);13.14dBm (ERIP for 5G)

Bluetooth Operating Frequency Range: 2402~2480MHz; Bluetooth Max Output Power: 6.85dBm(EIRP)

5150~5250 MHz can be used indoor only.

The following importer is the responsible party (contact for EU matters only)

Importer: Anker Technology (UK) Ltd

Importer Address: Suite B, Fairgate House, 205 Kings Road, Tyseley, Birmingham, B11 2AA, United Kingdom

Your product is designed and manufactured with high quality materials and components, which can be recycled and reused.

This symbol means the product must not be discarded as household waste, and should be delivered to an appropriate collection facility for recycling. Proper disposal and recycling helps protect natural resources, human health and the environment. For more information on disposal and recycling of this product, contact your local municipality, disposal service, or the shop where you bought this product.

FCC Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. this device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause undesired operation.

Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

RF Exposure Information (SAR)

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20cm between the radiator and your body.

This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions:

1. this device may not cause interference, and
2. this device must accept any interference, including interference that may cause undesired operation of the device.

This Class B digital apparatus complies with Canadian ICES-003.

IC RF Statement

When using the product, maintain a distance of 20cm from the body to ensure compliance with RF exposure requirements.

This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter.

Notice: Shielded cables

All connections to other computing devices must be made using shielded cables to maintain compliance with FCC regulations.

The following importer is the responsible party.
Company Name: Fantasia Trading LLC
Address: 9155 Archibald Ave, Suite 202, Rancho Cucamonga, CA 91730, USA
Telephone: 1-800-988-7973

For FAQs and more information, please visit:
www.SeeNebula.com
support@SeeNebula.com

+1 (800) 988 7973 (US) Mon-Fri 9:00am - 5:00pm (PT)
+44 (0) 1604 936200 (UK) Mon-Fri 6:00 - 11:00 (GMT)
+49 (0) 69 9579 7960 (DE) Mo-Fr 6:00 - 11:00

©Anker Innovations Limited. All rights reserved. NEBULA and the NEBULA logo are trademarks of Anker Innovations Limited, registered in the United States and other countries.
Anker Innovations Limited
Room 1318-19, Hollywood Plaza, 610 Nathan Road,
Mongkok, Kowloon, Hong Kong

Model: D2400 51005002176 V01