TP-Link VIGI C540-W Quick Start Manual

Quick Start Guide
VIGI Wi-Fi Network Camera
*Images may differ from actual products.
Appearance
Status LED Indication
Status Description
Solid red Starting up
Blink red and green Ready for setup
Blink green slowly Connecting to Wi-Fi
Solid green Connected to Wi-Fi
Blink red slowly Wi-Fi connection lost
Blink red quickly Camera resetting
Blink green quickly Camera updating
1
Mount Camera
Wall Mounting
Option 1: Wall/Ceiling Mounting
1. Stick the mounting template to the desired mounting place. Drill 4 screw holes
according to the template.
2. Insert the anchors into the holes, use the provided screws to fix the camera's
bracket to the wall or ceiling.
Note: Make sure that the wall is strong enough to withstand 3 times the
weight of the camera and mounting bracket .
Mounting Template
Anchor
Self-tapping Screw
Installing Waterproof Cable Attachments
Install the waterproof cable attachments for the network interface when the
camera is installed outdoors.
Note: Make sure each part is securely attached and the waterproof rings are flush to keep out water.
Fix Nut Waterproof Waterproof
Jacket
Ring
1. Route the network cable through the following components in order: fix nut,
waterproof ring, and then the waterproof jacket.
2. Fix the O-ring to the network interface of the camera and connect the network
cables.
3. Attach the network interface with the waterproof jacket, then twist to lock.
4. Insert the waterproof ring into the waterproof jacket. Rotate the fix nut to
secure it to the waterproof jacket.
1
Power Supply Interface
2
(12V DC)
Infrared LED
1
Status LED
2 Built-in Microphone
5
3
White LED
4
6
5
6
OR
Self-tapping Screw
O-ring Network
Interface
Package Contents
7
Speaker
7
Micro SD Card Slot
8
Insert a micro SD card for local storage. Initialize the SD card via VIGI app before
recording videos.
Reset Button
9
Long press the button to reset the camera to factory settings.
Option 2: Pole Mounting
1. Thread each of the two cable ties through the slits on the back of the camera's
bracket indicated below.
2. Slip the two cable ties through the pole. Tighten them to firmly attach the pole.
Mounting Template
Anchor
Install Waterproof Seal for Power Connectors
Install the waterproof seal for the power connectors when the camera is installed
outdoors.
Male Power Connector
Network Camera
Waterproof Seal
Anchors x 4
Quick
Mounting Template Start
Guide
8
9
Note: Before inserting the micro SD card or resetting
the camera, rotate the sphere and unfasten the two
fixed screws to remove the cover.
Cable Tie
Female Power Connector
Waterproof Seal
Power Adapter
Waterproof Cable
Attachments
Screws x 4
Quick Start Guide
Cable Tie