Connecting The Network Color Laser Printer - GE Voluson E Series Service Manual

3.5.5 Connecting the Network Color Laser Printer

Caution
Please observe that the complete Printer Assembly has to be located outside of the patient environment
(according to IEC 60601-1).
Caution
The printer being used may not be a medical device. The (Bluetooth) Printer Set and the Power Supply is
also not a medical device. The equipment meets the requirements of the EN 60950 Standard.
It does not matter, whether an Ethernet crossover cable or a patch cable (straight through cable) is used.
Note
The Network Color Laser Printer automatically reconfigures signals to yield expected results.
The Network Color Laser printer MUST NOT be installed by the user! For installation please contact your
Note
local distributor or GE service representative.
Connection directly to the Voluson E-Series
Physical connection:
1. Connect the Color Laser Printer.
-
Connect the network cable to the Ethernet LAN connector on the Voluson E-Series system. The
other end connect to the Ethernet connector of the Color Laser Printer.
-
Connect the power cable of the printer to an external, non-isolated power source.
Voluson E-Series Service Manual
5539550APB Revision 6
Figure 3-13 Connection Scheme - Color Laser Printer (directly via network cable)
Setup Instructions
3-21