Replacement Of Key Caps (By Special Native Language Keys); Key Caps - Removal Procedure; Key Caps - Installation Procedure - GE Voluson E Series Service Manual

Replacement Procedures

8.13 Replacement of Key Caps (by special native language keys)

The table in Section 9.8 "Options and Upgrades" on page 9-28
Note
be removed depend on the (special native) language kit.
Manpower
One person, 30 minutes
Tools
small-sized slotted screwdriver or tweezers
Preparations
1. Power Off/Shutdown the system as described in

8.13.1 Key Caps - Removal Procedure

1. Place a small slotted screwdriver between the Key Cap to be removed and its neighboring Key Cap.
2. Gently lift the Key Cap, until it is completely loosened from its base.
3. Remove the Key Cap.

8.13.2 Key Caps - Installation Procedure

1. Carefully place the appropriate Key Cap in position on the keyboard, taking care to place the plastic
alignment pin in the correct position so that the Key Cap is the right way up and reads correctly.
2. Push the Key Cap down until it snaps into position.
3. Power On/Boot Up the system as described in
4. Setup the Keyboard Language Layout as described in
keyboard to check the function of each key.
8-24
Section 4.2.2 on page 4-4
Figure 8-30 key cap replacement
Section 4.2.1 on page 4-3
shows the available Key Cap Kits. Keys to
.
.
Section 6.4 on page 6-5 and then type with the
Voluson E-Series Service Manual
5539550APB Revision 6