Connection Wiring Diagram Single Zone Hydronic Kit; Internal Unit - Immergas SUPER TRIO Instruction Booklet

1.8 CONNECTION WIRING DIAGRAM SINGLE ZONE
HYDRONIC KIT (SECOND ZONE OPTIONAL) AND
MAGIS PRO - MAGIS PRO V2 INTERNAL UNIT.
Once the kit is assembled, proceed with the wiring according to
the diagram Fig. 34.
- Connect the cables in the Magis Pro - Magis Pro V2 Interna Unit
control panel following the connection diagram in Fig. 40 - 41.
- Lower the wiring exiting the Magis Pro - Magis Pro V2 Interna
Unit until it can be secured with the clips (1-2).
- Connect the storage tank probe terminals (4) to the device ter-
minal block / terminal board (see wiring diagram Fig. 40 - 41)
and position it on the storage tank unit in the appropriate seat
(Fig. 35), using the relative cable clamp.
- Connect the flow probe connector (10) to the wiring marked
by the label "SONDA" (PROBE), then connect the wiring to the
probe and connect the "T-SIC" connector to the safety thermo-
stat (Only if the second optional zone is present).
- Connect the connector with the red "M-Z1" label to the pump
34
102
1
6
4
9
/ circulator (7) and connect the wiring terminals to the device
terminal block / terminal board (see wiring diagram Fig. 40 - 41).
- Connect the connector with the green "M-Z2" label to the pump
/ circulator (8) (Only if the second optional zone is present).
- Connect the connector of the mixing valve (6) marked with the
"V.MISC" (MIX.V) label (Only if the second optional zone is
present).
- Connect the antifreeze box connector (9) to the wiring connector
with the "ANTIFREEZE" label, and connect the wiring terminals
to the device terminal block / terminal board (see wiring diagram
Fig. 40 - 41).
- Make the connection to the power supply of the Internal Unit
using the cable (3) as shown in the wiring diagram (Fig. 40 - 41)
- Now group the various cables and join them with the clip (5)
supplied with the hydraulic manifold.
Attention: in order for the probes to function properly, before it
is inserted, it is recommended to put a bit of conductive paste on
the relative probe-holder.
2
3
5
7
8
10
N.B.: wind the uncovered fittings with the
insulation present in the kit.
DHW probe - positioning (Det. 4)
35