Immergas MAGIS M4-30 Use And Installation page 28

• Installation of rear cover.
Closing position
Posizione di chiusura
Flat-headed
Cacciavite
screwdriver
a taglio
Screw hole for three
Foro vite presente per
M4X20
tre M4X20
1) Insert a flat-headed screwdriver at the closing point at the bottom of the control panel and rotate the screwdriver to
remove the rear cover (be careful not to damage it).
2) Use three M4X20 screws to directly mount the rear cover on the wall.
3) Use two M4X25 screws to install the rear cover on the junction box 86 and use a M4X20 screw to fix it to the wall.
4) When inserting the screw plug in the wall, make sure it is flush with the wall.
5) Use the Phillips screws to fix the bottom cover of the control panel into the wall using the screw plug. Make sure that the
bottom cover of the control panel is at the same height after installation, then reposition the control panel on the bottom cover.
6) Do not overtighten the screw to prevent it from deforming the rear cover.
Rear cover
Coperchio posteriore
Coperchio
Front cover
anteriore
A
Lower left side wires outlet hole
Intaglio foro uscita fili
slit
lato inferiore sinistro
B
Wiring Foro
60mm
hole
cablaggio
Screw hole for three
Foro vite presente per
M4X20
tre M4X20
Foro vite presente su
Screw hole on junction box
scatola di derivazione 86,
86, use two M4X25mm
utilizzare due M4X25mm
Foro uscita
fili lato
Lower left
side wires inferiore
outlet hole sinistro
C
Wall hole and wiring hole
Foro parete e foro cablaggio
Diameter: Ø8 - Ø10
Diametro: Ø8 - Ø10
28
Rear cover
Coperchio
posteriore
Wires
Fili
cablaggio