Immergas MAGIS M4-30 Use And Installation page 107

If DOUBLE ZONE and ROOM TEMP. are set at YES, while WATER FLOW TEMP. is set at YES or NO, the following
pages will be displayed:
In this case, the setting value of zone 1 is T1S, the setting value of zone 2 is T1S2 (the corresponding T1S2 is calculated
based on the climatic curves).
10.5.6 Room thermostat.
Information on Room Thermostat.
The ROOM THERMOSTAT setting is used if the room thermostat is available.
How to set the Room Thermostat.
Go to MENU>FOR SERVICEMAN>6. ROOM THERMOSTAT.
Press OK. The following page will be displayed:
NOTE
ROOM THERMOSTAT. = NO, no room thermostat.
ROOM THERMOSTAT = MODE SETTING, wiring of the room thermostat must follow method A.
ROOM THERMOSTAT = ONE ZONE, wiring of the room thermostat must follow method B.
ROOM THERMOSTAT = DOUBLE ZONE, wiring of the room thermostat must follow method C
(see 9.7.6 Connection for other components/For the room thermostat).
10.5.7 Other Heating Source.
The OTHER HEATING SOURCE is used to set the parameters of the indoor unit backup heater (IBH).
Go to MENU>FOR SERVICEMAN>7. OTHER HEATING SOURCE.
Press OK. The following page will be displayed:
Homepage (zone 1)
Homepage (zona 1)
6. ROOM THERMOSTAT
6 TERMOSTATO AMB.
6.1 ROOM THERMOSTAT 6.1 TERMOSTATO AMB.
MODIFICA ADJUST
7. OTHER HEATING SOURCE
7 ALTRA FONTE RISCALDAMENTO
7.1 dT1_IBH_ON
7.2 t_IBH_DELAY
7.3 T4_IBH_ON
7.4 dT1_AHS_ON
7.5 t_AHS_DELAY
MODIFICA ADJUST
7. OTHER HEATING SOURCE
7 ALTRA FONTE RISCALDAMENTO
7.6 T4_AHS_ON
7.7 POSIZ. IBH 7.7 IBH LOCATE
7.8 P_IBH1
7.9 P_IBH2
7.10 P_TBH
MODIFICA ADJUST
107
2
Additional page (zone 2)
Pagina aggiuntiva (zona 2)
(The double zone is effective)
(La doppia zona è efficace)
NO NO
1/2
5°C
30MIN
-5°C
Not used
Non utilizzato
Not used
Non utilizzato
2/2
Not used
Non utilizzato
ANEL.TUBO
PIPE LOOP
0,0kW
0,0kW
2,0kW