Display Assembly - HP ENVY x360 Maintenance And Service Manual

Display assembly

To remove and disassemble the display assembly, use these procedures and illustrations.
Full hinge-up displays are not available as spare parts. Spare parts for displays are
available only at the subcomponent level.
Before removing the display panel, follow these steps:
1. Prepare the computer for disassembly (see
2. Remove the bottom cover (see
3. Disconnect the battery cable from the system board (see
Remove the display assembly:
1. Remove the plastic protector and then disconnect the wireless antenna cables (1)
from the WLAN module.
2. Disconnect the camera cable (2) from the ZIF connector on the system board.
3. Remove the Mylar and then disconnect the display cable (3) from the ZIF connector
on the system board.
4. Remove the display cable from the clips along the sides of the fan (4).
5. Remove the six Phillips M2.5 × 5.0 screws (1) that secure the display assembly to
the computer.
Preparation for disassembly on page
Bottom cover on page 41).
Battery on page 43).
Display assembly
41).
67