GE JBP15DMBB Use And Care Manual page 30

Cleaning the glass cooktop.
Our testing shows that
if you are cooking high
sugar mixtures such as
jelly or fudge and have
a spillover, it can cause
permanent damage to the
glass surface unless the
spillover is immediately
removed.
30
(on some models)
Metal Marks and Scratches
Be careful not to slide pots and pans
across your cooktop. It will leave metal
markings on the cooktop surface.
These marks are removable using
the CERAMA BRYTE
®
Cleaner with the CERAMA BRYTE
Cleaning Pad for Ceramic Cooktops.
Cooktop Seal
To clean the cooktop seal around the edges
of the glass, lay a wet cloth on it
Damage from Sugary Spills and Melted Plastic
Turn off all surface units. Remove hot
pans.
Wearing an oven mitt:
a. Use a single-edge razor blade
scraper (CERAMA BRYTE
Cooktop Scraper) to move the spill
to a cool area on the cooktop.
b. Remove the spill with paper towels.
To Order Parts
To order CERAMA BRYTE
®
Cleaner and the cooktop scraper, please
call our toll-free number:
National Parts Center . . . . 800.626.2002
CERAMA BRYTE Ceramic
®
Cooktop Cleaner . . . . . . . . . .# WX10X300
CERAMA BRYTE Ceramic
®
Cooktop Scraper . . . . . . . . .# WX10X0302
Kit . . . . . . . . . . . . . . . . . . . . . . . .# WB64X5027
(Kit includes cream and cooktop scraper)
CERAMA BRYTE Cleaning Pads for
®
Ceramic Cooktops . . . . . . .# WX10X350
Ceramic Cooktop
®
bottom of pans for roughness that would
scratch the cooktop.
for a few minutes, then wipe clean with
nonabrasive cleaners.
.
Ceramic
®
NOTE: If pitting or indentation in the glass
surface has already occurred, the cooktop
glass will have to be replaced. In this case,
service will be necessary.
Ceramic Cooktop
If pots with a thin overlay of aluminum
or copper are allowed to boil dry, the
overlay may leave black discoloration
on the cooktop. This should be removed
immediately before heating again or the
discoloration may be permanent.
WARNING:
Carefully check the
Any remaining spillover should be left
until the surface of the cooktop has
cooled.
Don't use the surface units again until
all of the residue has been completely
removed.