Water Pressure Gauge - BRP EVINRUDE E-TEC 115 HP 2011 Service Manual

Water Pressure Gauge

To display engine water pressure, install a water
pressure hose fitting in the cylinder block as
shown.
Use Pipe Sealant with Teflon on the threads of the
hose fitting. Refer to installation instructions sup-
plied with gauge.
Route the water pressure hose around the star-
board side of the powerhead along the same path
as the battery cables.
1. Water pressure hose fitting
For an I-Command water pressure display, sev-
eral water pressure sensor kits are available.
Refer to the Evinrude/Johnson Genuine Parts
and Accessories catalog.
OUTBOARD RIGGING CONNECTIONS
To send water pressure data to the EMM, along
with an I-Command display, install Water Pressure
Transducer Kit, P/N 5008300.
1
1. Water pressure transducer
1
Connect the transducer lead to the engine wiring
harness connector.
1
004959
1. Water pressure transducer lead
2. Engine harness connector
ROUTINE SERVICE
008129
2
004962
23
2