Lifting The Outboard; Outboard Rigging Connections - BRP EVINRUDE E-TEC 115 HP 2011 Service Manual

LIFTING THE
OUTBOARD
WARNING
To avoid personal injury, make sure the lift-
ing capacity of the hoist is at least twice
the weight of the outboard.
DO NOT allow the lift hook or chain from
the hoist to come in contact with any part
of the engine during lifting.
Use correct Lifting Fixture to lift outboard:
Model
60° V4–V6
Install Lifting Fixture, P/N 342672, on crankshaft.
Tighten mounting screw securely using an Allen 1/
4 in. hexagonal wrench.
1. Center retaining screw
Fasten appropriate chain hook to eye of tool.
Carefully hoist outboard with chain and unbolt out-
board mounting brackets from frame.
OUTBOARD RIGGING
CONNECTIONS
IMPORTANT:
and remote control installation information, refer to
the Predelivery and Installation Guide included
with the service manual set.
Common Practices – All Models
Control Cable Identification
IMPORTANT:
identified before rigging outboard.
Identify each control cable:
Lifting Fixture
•
P/N 342672
1
1. Shift cable casing guide extended to midpoint
2. Throttle cable casing guide retracted
Extend the control cables and lubricate them with
Triple-Guard grease.
004945

LIFTING THE OUTBOARD

For complete outboard rigging
Control cable function must be
Put the control handle into NEUTRAL position.
The throttle cable casing guide will retract com-
pletely and the shift cable casing guide will go to
the midpoint of its travel.
ROUTINE SERVICE
1
2
DP0811
30501
15
2