Troubleshooting - Miracle-Ear EarLINK Remote AV User Manual

Basic Use
Lanyard (optional)
1. Insert thin cord into end of the Miracle-EarLINK
Remote AV housing until loop is exposed.
2. Thread lanyard through loop and pull lanyard.
NOTE: Lanyards (part #90974-000) can be obtained from your
hearing professional.
1
10
™
2

Troubleshooting

SYMPTOM POSSIBLE CAUSES
LEDs do not The Miracle-EarLINK
illuminate when Remote AV is in
button is pressed. locked state.
After moving lower
switch to Unlock
position, it may
take a brief time to
wirelessly "locate"
your hearing aids.
LEDs illuminate,
Hearing aids are
but hearing aids
not paired with the
do not respond to
Miracle-EarLINK
a button press.
Remote AV.
Battery level in
hearing aid can
no longer support
wireless activity.
Set of hearing
Less than two
aids fail to pair
hearing aids were
with the
found during pairing
Miracle-EarLINK ™
process.
Remote AV.
Only one hearing Ear selection switch
aid is receiving is in the left or right
commands. position.
Troubleshooting
SOLUTIONS
Move lower switch
™
from Lock (right)
to Unlock (left)
position.
Wait for about
a second after
unlocking before
pressing a button.
Perform pairing
process with your
hearing aids and
™
Miracle-EarLINK ™
Remote AV.
Install new hearing
aid battery.
During pairing
process, make
sure both hearing
aids are available.
Move ear selection
switch to center
(both) position.
11