Connecting To Audio Sources; Pairing - Miracle-Ear EarLINK TV Streamer AV User Manual

Connecting to Audio Sources

There are different ways to attach an audio source to the
Miracle-EarLINK TV Streamer AV. Carefully examine an
™
electronic audio source to determine which AUDIO OUT
options it offers.
Insert cable into the
AUDIO OUT jack on
your electronic audio
source
Optical TOSLINK
Analog RCA to
3.5 mm
Audio Out
Note: Connect the red-to-
red and white-to-white.
Tip: During initial setup, a solid blue LED confirms the audio
cable is properly attached to the Miracle-EarLINK
Streamer AV and audio streaming is active.
12
Attach the other
end of cable to
the rear of the
Miracle-EarLINK
™
TV Streamer AV
Use jack B
B C
Audio Out
Use jack C
B C
™ TV
For the Miracle-EarLINK TV Streamer AV to interact with your
™
hearing aid(s), you must first pair the Miracle-EarLINK
AV with each hearing aid. You only need to perform this action one
time, as they should automatically recognize each other when both
are powered on and within wireless operating range.
To pair the Miracle-EarLINK
™
1. Ensure your hearing aids are not connected to nearby Bluetooth
devices. To do this:
• Disable Bluetooth on your mobile phone.
®
• Power off any nearby Miracle-EarLINK
accessories, which you previously paired to your hearing aids.
2. Power off, then power on your hearing aids.
3. Place your hearing aids within 15 cm (6 inches) of the
Miracle-EarLINK TV Streamer AV.
™
4. Press the button on the Miracle-EarLINK
The front LED will begin blinking blue. Audio streaming will be
temporarily stopped during this step.
* Typical operating range is up to 15 meters (~50 feet). Operational range may be reduced by
environmental factors, such as obstructions, interference, and human body positioning. Larger
operational distances are achievable, though audio quality and connectivity may decrease.

Pairing

TV Streamer
™
*
TV Streamer AV with your hearing aid(s):
TV Streamer AV or
™
TV Streamer AV.
™
®
13