Table of Contents
Advertisement
Troubleshooting
Problem
The Forks do not
Insufficient oil.
raise completely.
The forks will
1. Insufficient oil.
not raise.
2. Air in valve chamber.
3. Old/contaminated oil.
The forks will
1. Deformed piston rod.
not descend.
2. Piston rod rusted.
3. Control handle, bolt, or
Fluid Leak.
Component, likely seal,
worn or damaged.
Forks descend
1. Contaminated oil clogging valve.
without operating
2. Hydraulic component damaged.
release valve.
Follow safety precautions whenever
diagnosing or servicing the tool.
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST AND ASSEMBLY
DIAGRAM IN THIS DOCUMENT AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER
OR DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE
BUYER THAT HE OR SHE IS QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT, OR
THAT HE OR SHE IS QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE
MANUFACTURER AND/OR DISTRIBUTOR EXPRESSLY STATES THAT ALL REPAIRS AND PARTS
REPLACEMENTS SHOULD BE UNDERTAKEN BY CERTIFIED AND LICENSED TECHNICIANS,
AND NOT BY THE BUYER. THE BUYER ASSUMES ALL RISK AND LIABILITY ARISING OUT OF
HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO,
OR ARISING OUT OF HIS OR HER INSTALLATION OF REPLACEMENT PARTS THERETO.
Record Serial Number Here:
Note: If product has no serial number, record
month and year of purchase instead.
Note: Some parts are listed and shown for illustration purposes
only, and are not available individually as replacement parts.
Specify UPC 193175436795 when ordering parts.
58306
Possible Causes
chain broken or missing.
For technical questions, please call 1-888-866-5797.
Likely Solutions
Refill Jack with hydraulic oil
through Oil Plug hole.
1. Refill Jack with hydraulic oil
through Oil Plug hole.
2. Raise the Control Lever to the
Upper position and pump the
handle several times.
3. Change oil and replace Seals.
1. Replace piston rod and cylinder.
2. Lubricate/replace rod. Keep Jack in
lowered position when not in use.
3. Replace the Handle Assembly.
Inspect and replace worn or damaged parts.
1. Clean valve with kerosene and change oil.
2. Replace damaged part.
Page 7
Advertisement
Table of Contents
