HP 15-fb0 Series Maintenance And Service Manual page 66

a. Remove the two Phillips 1.6 × 2.5 screws (1) that secure the top bracket, lift up the hinge brackets
slightly (2), and then pull the top bracket out from under the hinge brackets to remove it (3). The
top bracket is available as spare part number N13330-001.
b. Use a tool to lift up evenly across the module and peel the module up from the display back cover
(1), and then disconnect the cable from the reverse ZIF connector on the module (2). The camera
module is available as spare part number N13328-001.
NOTE:
the module.
7. If you need to remove the hinges from the display back cover:
a. Remove the five broadhead Phillips M2.0 × 2.0 screws (1) from each hinge.
b. Remove the display hinges (2).
The display hinges are available using spare part number N13329-001.
60 Chapter 6 Removal and replacement procedures for authorized service provider parts
For installation, note that the cable routes under the camera module before it connects to