Display Assembly - HP 15-fb0 Series Maintenance And Service Manual

1. Remove the four Phillips 2.0 × 2.0 broadhead screws (1) that secure the fin to the computer, and then
remove the fin (2).
2. Remove the four Phillips M2.0 × 2.0 broadhead screws (1) and two Phillips M2.0 × 2.5 screws (2) that
secure the plastic rear vent to the computer, and then remove the vent (3).
To install the plastic rear vent and fin, reverse these procedures.

Display assembly

To remove and disassemble the display assembly, use these procedures and illustrations.
NOTE: You can remove the bezel, display panel, and camera module without removing the entire display
assembly from the computer. For more information, see
display) on page
Full hinge-up displays are not available as spare parts. Spare parts for displays are available only at the
subcomponent level.
Before removing the display assembly, follow these steps:
56 Chapter 6 Removal and replacement procedures for authorized service provider parts
39. You do have to remove the display assembly to remove the remaining subcomponents.
Display subcomponents (without removing the