Heat Sink - HP 15-fb0 Series Maintenance And Service Manual

4. Remove the card reader (5).
To install the card reader, reverse this procedure.

Heat sink

To remove the heat sink, use these procedures and illustrations.
Table 6-9 Heat sink descriptions and part numbers
Description
Heat sink for use in models with RTX 3050 or 3050Ti
Heat sink for use in models with GTX 1650 graphics
Heat sink for use in models with RX 6500M graphics
Before removing the heat sink, follow these steps:
1. Prepare the computer for disassembly (see
2. Remove the bottom cover (see
3. Disconnect the battery cable from the system board (see
Remove the heat sink:
1. Remove the Phillips M2.0 × 2.0 screw (1) from the plastic holder at the top of the computer, and then
remove the holder (2).
2. In the order indicated on the heat sink, loosen the seven captive Phillips screws (3) that secure the heat
sink to the system board.
Preparation for disassembly on page
Bottom cover on page 36).
36).
Battery on page 38).
Spare part number
N13305-001
N13306-001
N14593-001
Heat sink 49