Card Reader - HP 15-fb0 Series Maintenance And Service Manual

3. Lift the back of the board up, and then pull the board into the computer to remove it (4).
To install the I/O board, reverse this procedure.

Card reader

To remove the card reader, use this procedure and illustration.
Table 6-8 Card reader description and part number
Description
Card reader
Card reader cable
Before removing the card reader, follow these steps:
1. Prepare the computer for disassembly (see
2. Remove the bottom cover (see
3. Remove the battery (see
Remove the card reader board:
1. Disconnect the cable from the ZIF connector on the system board (1).
2. Remove the Phillips M2.0 × 4.0 screw (2) that secures the bracket, and then remove the bracket (3).
3. Remove the two Phillips M2.0 × 2.5 screws (4) that secure the card reader to the computer.
48 Chapter 6 Removal and replacement procedures for authorized service provider parts
Preparation for disassembly on page
Bottom cover on page
Battery on page 38).
36).
Spare part number
N13302-001
N13303-001
36).