Display Subcomponents (Without Removing The Display) - HP 15-fb0 Series Maintenance And Service Manual

WARNING! To reduce potential safety issues, use only the user-replaceable battery provided with the
computer, a replacement battery provided by HP, or a compatible battery purchased from HP.
IMPORTANT:
information. To prevent loss of information, save your work or shut down the computer through Windows
before you remove the battery.
Remove the battery:
1. Disconnect the battery cable (1) from the system board.
2. Remove the six Phillips M2.0 × 5.0 screws (2) that secure the battery to the computer.
3. Remove the battery (3).
To install the battery, reverse the removal procedures.

Display subcomponents (without removing the display)

You can remove some display subcomponents without removing the entire display assembly from the
computer. To remove the bezel, display panel, and camera module, use these procedures and illustrations.
Before removing the display subcomponents, follow these steps:
1. Prepare the computer for disassembly (see
2. Remove the bottom cover (see
3. Disconnect the battery cable from the system board (see
Remove the display assembly:
1. You can remove the bezel with the display assembly connected to the computer. To remove the bezel:
a. Flex the top (1), the left and right sides (2), and then the bottom of the bezel (3) to release it.
b. Remove the bezel from the display (4).
NOTE:
Removing a battery that is the sole power source for the computer can cause loss of
Bottom cover on page
The display assembly remains attached to the computer for these procedures.
Preparation for disassembly on page
36).
Battery on page
Display subcomponents (without removing the display)
36).
38).
39