Table of Contents
Advertisement
Available languages
Available languages
STEP 1 - PREP
1.
Clean your toilet
2.
Turn off the cool water supply at the wall beside the toilet
3.
Drain the toilet tank completely by flushing the toilet
STEP 2 – ATTACH YOUR RAISED TOILET SEAT
1.
Turn both locking clamps counterclockwise until
they can no longer turn - this will open the locking
devices.
2.
Place raised toilet seat onto the bowl and position
securely. Be sure the two locking brackets are on
both sides of the bowl wall and that the seat is flush
to the bowl.
3.
Turn the locking brackets clockwise until tight, hand
tighten only. Do not use tools as threads on adjust-
ment bracket may strip.
NOTE:
•
Check for secure fit routinely before using product.
•
User's weight should be centered over toilet seat.
STEP 3 – COOL WATER CONNECTION
TIPS
•
You may need a wrench to disconnect the water supply hose.
•
Use a bucket or towel to catch excess water
1.
Disconnect the existing water supply hose
from the toilet tank
2.
Ensure o-ring is placed in the large adapter
3.
Attach the large adapter to the toilet tank
connection and screw the flexible steel
hose to the bottom connection
4.
Attach provided cool water supply hose to
the large adapter's side connection
5.
Attach the cool water supply hose provided
to the cool water port underneath the bidet
control panel
TIPS
•
Wrap teflon tape tightly around threads to create a watertight seal
•
Tighten by hand to avoid stripping the connection threads
STEP 4 – FINAL CHECK
•
Check connections are properly secured
•
Turn on the water supply at the wall
installation instructions
- 3 -
Advertisement
Table of Contents
