Display Assembly - HP 15 Maintenance And Service Manual

Display assembly

NOTE: Display assemblies are offered as spare parts only at a subcomponent level.
Before removing the display assembly, follow these steps:
1. Prepare the computer for disassembly
2. Remove the bottom cover (see
3. Remove the battery (see
4. Remove the WLAN module (see
Remove the display assembly:
1. Disconnect the wireless antenna cables from the WLAN module and remove the cable from the clips in
the computer (1).
2. Disconnect the display cable from the system board (2), and then remove the cable from the channel in
the left speaker (3).
3. Remove the six Phillips M2.5 × 4.0 screws (1) from the hinges.
4. Open the display (2) until the hinges (3) are in the open position.
50 Chapter 5 Removal and replacement procedures for authorized service provider parts
(Preparation for disassembly on page
Bottom cover on page
Battery on page 30).
WLAN module on page
27).
28).
34).