Battery Connector (Fanless Products Only) - HP 15 Maintenance And Service Manual

Battery connector (fanless products only)

Table 5-13 Battery connector description and part number
Description
Battery connector
Before removing the battery connector, follow these steps:
1. Prepare the computer for disassembly
2. Remove the bottom cover (see
3. Remove the battery (see
4. Remove the solid-state drive (see
5. Remove the heat sink (see
Remove the battery connector:
1. Disconnect the battery connector cable from the system board (1).
2. Remove the two Phillips M2.0 × 3.0 screws (2) that secure the connector to the computer.
3. Lift the battery connector out of the computer (3).
Reverse this procedure to install the battery connector.
46 Chapter 5 Removal and replacement procedures for authorized service provider parts
(Preparation for disassembly on page
Bottom cover on page
Battery on page 30).
Solid-state drive on page
Heat sink (thermal module) on page
27).
28).
33).
43).
Spare part number
L63585-001