Fingerprint Reader Board - HP 15 Maintenance And Service Manual

Fingerprint reader board

Table 5-9 Fingerprint reader board description and part number
Description
Fingerprint reader board
NOTE: The fingerprint reader board spare part kit does not include the cable. The cable is available as
spare part number L63596-001.
Before removing the fingerprint reader board, follow these steps:
1. Prepare the computer for disassembly
2. Remove the bottom cover (see
3. Remove the battery (see
4. Remove the card reader/audio board (see
Remove the fingerprint reader board:
1. Remove the Phillips M2.0 × 2.5 screw (1) that secures the fingerprint reader bracket to the computer.
2. Rotate the bracket upward (2), and then remove the bracket from the computer (3).
3. Disconnect the cable from the ZIF connector on the fingerprint reader board (4), and the remove the
board from the computer (5).
Reverse this procedure to install the fingerprint reader board.
40 Chapter 5 Removal and replacement procedures for authorized service provider parts
(Preparation for disassembly on page
Bottom cover on page
Battery on page 30).
Card reader/audio board on page
27).
28).
37).
Spare part number
L63595-001