Configuration Menu Options - SolarEdge SE3K-RWB Installation Manual

D a t e a n d T i m e
R e s e t C o u n t e r s
F a c t o r y R e s e t
S W U p g r a d e - S D C a r d
M a n u a l A F C I T e s t
D i a g n o s t i c s
G r i d P r o t e c t i o n
B o a r d R e p l a c e m e n t
E x i t
The options presented in these menus are described in the next section.

Configuration Menu Options

This section describes how to use the LCD menus for configuring the inverter.
Configuration is only available when the inverter ON/OFF switch is OFF. Use either the
internal LCD user buttons or the external LCD light button to move between and select
menu options.
Country and Grid
Configuring the country and grid is available using the internal user buttons only.
1. Select the Country option to specify the country or region in which the inverter is
installed and the grid to which it is connected. This parameter may arrive pre-
configured. If so, verify that it is set to the proper country or region.
WARNING!
The inverter must be configured to the proper country/ region in order to
ensure that it complies with the country grid code and functions properly
with the country grids.
A list of countries is displayed. If no country is configured, the value is <NONE>.
NOTE
If an inverter is not configured to any country, it will not produce energy,
and the following message will be displayed on the LCD:
No Country Selected
A plus sign (+) near the country indicates that another menu will be displayed after
selection.
2. Confirm your country selection in the confirmation screen: Toggle to YES and press
Enter.
Three Phase System MAN-01-00507-4.2
Chapter 6: User Interface 51