Table of Contents
Advertisement
Chapter 3: Installing the Inverter
Install the inverter either before or after the modules and power optimizers have been
installed.
CAUTION!
Do not rest the connectors at the bottom of the inverter on the ground, as it
may damage them. To rest the inverter on the ground, lay it on its back, front
or side.
Inverter Package Contents
One inverter with DC Safety Unit (if applicable)
One mounting bracket
Two Allen screws for fastening the inverter to the mounting bracket
DC Safety Unit sealing cover (if applicable, for use in case of inverter replacement)
Installation guide (with activation card and instructions)
Identifying the Inverter
Refer to the sticker on the inverter that specifies its Serial Number and its Electrical
Ratings. Provide the serial number when contacting SolarEdge support. The serial
number is also required when opening a new site in the monitoring platform.
Mounting the Inverter
The inverter is typically mounted vertically, and the instructions in this
section are applicable for vertical installation. Some three phase inverter
models can be installed horizontally (above 10° tilt) as well as vertically,
and at any tilt over 10° up to 90°. For information and instructions for
horizontal mounting refer to
http://www.solaredge.com/sites/default/files/application_note_horizontal_mounting_
of_three_phase_inverters.pdf.
The inverter is supplied with a mounting bracket.
Three Phase System MAN-01-00507-4.2
Figure 8: Mounting bracket
Chapter 3: Installing the Inverter
25
Advertisement
Table of Contents
Troubleshooting
