Reverse this procedure to install the power connector cable.
Display assembly
To remove and disassemble the display assembly, use these procedures and illustrations.
NOTE:
Display assemblies are offered as spare parts only at the subcomponent level.
Before removing the display panel, follow these steps:
1.
Prepare the computer for disassembly (see
2.
Remove the bottom cover (see
3.
Disconnect the battery cable from the system board (see
Remove the display assembly:
1.
Disconnect the antenna cables from the WLAN module (1), and then remove the cables from the clips
(2).
NOTE:
Bottom cover on page
One antenna cable routes through each hinge.
Preparation for disassembly on page
26).
Battery on page
Component replacement procedures
26).
28).
39