Display Assembly - HP 15-ew0 Series Maintenance And Service Manual

Table 5-7 System fan description and part number
Description
System fan (includes cable)
Before removing the system fan, follow these steps:
1. Prepare the computer for disassembly (see
2. Remove the bottom cover (see
3. Disconnect the battery cable from the system board (see
Remove the system fan:
1. Disconnect the system fan cable (1) from the system board.
2. Remove the two Phillips M2.0 × 4.1 screws (2) that secure the system fan to the computer.
3. Remove the system fan (3) from the computer.
Reverse this procedure to install the system fan.

Display assembly

To remove and disassemble the display assembly, use these procedures and illustrations.
IMPORTANT:
update the new ambient light sensor (ALS) data to the system BIOS. Please search for the related Service
Advisory in WISE for details.
IMPORTANT:
calibration update is available on the HP website under HP Customer Support – Software and Driver Downloads.
44 Chapter 5 Removal and replacement procedures for authorized service provider parts
Bottom cover on page
After replacing the display panel assembly, it is necessary to download and run the service tool to
After replacing the display panel assembly, it is necessary to reload the calibration data. The
Preparation for disassembly on page
34).
Battery on page
Spare part number
N09635-001
34).
36).