Regulatory And Safety Information - HP Compaq Presario,Presario S3150 Support Manual

Regulatory and Safety Information

WARNING: The Compaq Presario is heavy; be sure to use
ergonomically correct lifting procedures when moving the computer.
WARNING: Electrostatic discharge (ESD) can damage disk drives,
add-in cards, and other components. If an ESD station is not available,
wear a wrist strap attached to a metal part of the computer. Place cards
on a conductive foam pad or inside the conductive wrapper they came
in; do not place the cards on top of the wrapper.
WARNING: Do not operate the system with the cover removed.
Always replace the cover before turning on the system.
WARNING: Please read the "Additional Safety Information" located
later in this document before installing and connecting your system to
the electrical power system.
WARNING: Using the wrong type of memory module could damage
the system.
WARNING: Do not pull the memory module out of the socket. Use the
retaining clips to eject the module.
WARNING: Do not overload the system by installing add-in cards
that draw excessive current. The system is designed to provide 2 amps
(average) of +5 V power for each board/card in the computer. The
total +5 V current draw in a fully loaded system (one with all add-in
card slots filled) must not exceed the total number of slots multiplied by
2 amps.
WARNING: Be careful of the sharp edges on the expansion slot cover.
WARNING: There is danger of an explosion if the battery is incorrectly
replaced. Replace only with the same, or equivalent, type of battery.
Discard used batteries according to the manufacturer's instructions.