Important: If 30 seconds pass before you
complete step 3, you must repeat step 2
and step 3 to set the mouse ID. If the
ID button is pressed more than one time
during the mouse setup (step 3), you
must start over with step 2 and set the
receiver ID.
3 On the bottom of the mouse, press the
ID button (N) once with a blunt pointed object.
The mouse sends a new ID and flashes the
mouse sensor light (M3) three times. The
receiver flashes its blue activity light (J) three
times and then stops to show it has accepted
the new ID for the mouse.
6
Installing the Optical Wireless Mouse Set
Note: At this time, when you move the mouse
across a surface, the blue activity light (J)
on the receiver goes on and off indicating
the mouse and the receiver are working
together.
Important: The mouse goes into a sleep or
suspend mode after 20 minutes of inactivity.
Click a button on the mouse to wake it.
(Moving the mouse does not wake it.)
N
M3