Table of Contents
Advertisement
d.
When installing a display panel, be sure to install the adhesive tape in the locations on the inside of
the display back cover, as shown in the following illustration.
10.
If you need to remove the hinges from the display rear cover:
a.
Remove the three Phillips M2.5 × 2.5 screws (1) from each hinge.
b.
Remove the Phillips M2.5 × 4.0 screw (2) from each hinge.
c.
Remove the hinges from the display back cover (3).
The hinges are available in the Hinge Kit as spare part number M50409-001.
11.
If you need to remove the display and camera cable, disconnect the cable from the camera module (1),
and then release the cable from the display rear cover (2).
The display and camera cable is available as spare part number M50427-001.
54
Chapter 5 Removal and replacement procedures for authorized service provider parts
Advertisement
Table of Contents
