Table of Contents
Advertisement
8.
If you need to remove the camera module:
Use a tool to lift up evenly across the module and peel the module up from the display back cover
▲
(1), and then disconnect the cable from the module (2).
The camera module is available as spare part number M50436-001.
9.
If you need to remove the display panel:
a.
The display panel is secured to the display enclosure with stretchable release tape that is installed
under the left and right sides of the panel. To remove the panel, use tweezers to grasp the end of
the tape (1). While turning the tweezers, wrap the tape around the tweezers (2) as you continue to
pull the tape out from behind the display panel (3). You must pull the tape multiple times before it
is completely removed.
b.
Rotate the display panel over and place it next to the display rear cover (4).
Display panels are available as the following spare part numbers:
M52184-001: FHD, UWVA, 300 nits
52
Chapter 5 Removal and replacement procedures for authorized service provider parts
Advertisement
Table of Contents
