Display Assembly - HP 470 17 inch G9 Notebook PC Maintenance And Service Manual

Table 5-13 Speaker description and part number
Description
Speaker Kit
Before removing the speakers, follow these steps:
1. Prepare the computer for disassembly (see
2. Remove the bottom cover (see
3. Remove the battery (see
4. Remove the solid-state drive (see
5. Remove the WLAN module (see
6. Remove the fan (see
7. Remove the system board with the heat sink installed (see
Remove the speakers:
1. Lift the protective tape that covers the cable between the speakers (1).
2. Use a tool to release both speakers (2). The speakers are secured with adhesive.
3. Remove the speakers from the computer (3) .
To install the speakers, reverse this procedure.

Display assembly

To remove and disassemble the display assembly, use these procedures and illustrations.
Full hinge-up displays are not available as spare parts. Spare parts for displays are available only at the
subcomponent level.
Preparation for disassembly on page
Bottom cover and rubber feet on page
Battery on page 32).
Solid-state drive on page
WLAN module on page
Fan on page 42).
30).
35).
36).
System board on page
Spare part number
M50412-001
30).
46).
Display assembly 49