Wireless Wheel Mouse; Memory - HP Compaq Presario,Presario 5124 Quick Start Manual

Symptom
Mouse does not work after
installation or is not detected.
Poor reception.
Mouse stops functioning.
Symptom
Insufficient memory message
is displayed.
M P —G S
Y RESARIO ETTING TARTED

Wireless Wheel Mouse

Problem
Receiver is not
connected properly.
Batteries are not
installed properly.
Communication
between receiver and
mouse not established.
Receiver too close to
other electrical
devices.
Batteries are low.

Memory

Problem
All memory in
computer is being
used by open
programmes, and
memory is needed for
desired task.
Solution
Try unplugging then reconnecting the receiver
cable to your computer. The receiver cable goes
into the computer's USB port or PS/2 mouse port.
Reinstall the batteries according to the diagram
inside the battery compartment.
Press the Connect button on the receiver, then
press the Connect button under the mouse. See
step 6 in the "Compaq/Logitech Wireless Wheel
Mouse" section for more information.
Place the receiver at least 8 inches or 20
centimeters away from other electrical devices,
such as the computer, the computer monitor, or
external storage devices.
If you are working on a metallic surface, try
turning the receiver on its side.
Replace the batteries.
Solution
To avoid Windows automatically running
unnecessary programmes at startup:
1. From the Windows desktop, click the Start
button.
2. Select Run.
3. In the Open box, type MSCONFIG.
4. Click OK. The System Configuration Utility
dialog box is displayed.
5. Click the Startup tab, and clear the check
box(es) for any unnecessary programmes.
Close one or more programmes, and restart
Windows to recover memory. If the error
message is displayed again, repeat the
preceding steps and close one or more
programmes.
N S H ? 6-13
EED OME ELP