Huebsch Alliance Laundry Systems TR7104WN User Manual page 31

Washer Symptom
Er, FL on digital display
Er, dr on digital display
Er, PS on digital display
Er, Lo on digital display
Er, LLon digital display
Er, nF on digital display
Er, OF on digital display
Er, LUon digital display
Er, Ll on digital display
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
• This code will appear if the washer has not reached the fill level after 30 minutes
during a wash or rinse fill.
• Make sure hot and cold water faucets are turned on.
• Make sure that the fill hoses are not kinked or twisted.
• Clean the screens in the water mixing valve and the filter screens located at the
faucet end of the fill hoses.
• Unplug the machine for 15 seconds to clear this code.
• This code indicates that water is still in the washer at the end of the cycle.
• Check the drain hose and drain receptacle to make sure they are installed properly
and not blocked.
• Unplug the machine for 15 seconds to clear this code.
• The control has detected trouble sensing the water fill level.
• Unplug the machine and call for service.
• The control senses that the lid is open during a running cycle.
• Unplug the machine to clear this code.
• The control senses that the lid has unlocked during a running cycle.
• Unplug the machine to clear this code.
• The washer has not filled to the proper water level.
• No or very little change in water level has been sensed within 5 minutes of the cur-
rent fill.
• Make sure hot and cold water faucets are turned on.
• Make sure that the fill hoses are not kinked or twisted.
• Clean the screens in the water mixing valve and the filter screens located at the
faucet end of the fill hoses.
• Unplug the machine for 15 seconds to clear this code.
• This code indicates the washer has filled to the overflow level.
• The machine will begin to attempt to pump water out if the lid is closed and locked.
• If the code does not clear, unplug the machine and call for service.
• The control senses that the lid will not unlock.
• Unplug the machine for three minutes to unlock the lid.
• If the code appears again, call for service.
• This code indicates that the lid has not locked.
• Make sure the lid is closed all the way and try to start the cycle.
• Open the lid or unplug the machine to clear the code.
• If this code continues, call for service.
31
Possible Cause/Solution
Troubleshooting
Table continues...
Part No. 204949EN