Control Panel; Digital Display; Cycles - Huebsch Alliance Laundry Systems TR7104WN User Manual

Control Panel

Digital Display

The two-digit display is used to show the time remaining in a
cycle.
If the cycle time is over 99 minutes the control will display 1H,
2H, etc., and then the additional minutes over one or two
hours. If the cycle time is over nine hours, the cycle will round
up to the nearest hour and the control will display 10 and then
Hr.
At the end of a cycle, the control will display 01 while the ma-
chine checks to make sure it is safe to unlock the lid. Once the
lid is unlocked, the display will show 00 and the red Lid
Locked status light will turn off.
When the control is powered off, the right-most decimal in the
display will flash every five minutes to indicate that the ma-
chine is in Idle Mode.
The display also shows diagnostic codes.
Idle Mode
If no keypads have been pressed for five minutes after a cycle
is finished, the control will enter Idle Mode. A light in the lower
right corner of the digital display will flash quickly once every
five minutes. Press the Power/Cancel keypad to exit this mode
and power the display for cycle/option selection. This light will
flash again after five minutes when it re-enters Idle Mode.
Keypress Audio
The audio signal that sounds when a keypad is pressed can be
turned on or off.
Press and hold both the Perm Press and Rinse & Spin keypads
at the same time to turn the audio signal on or off.
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT

Cycles

The following cycle descriptions will help determine which cy-
cle to choose depending on the type of laundry being washed.
The descriptions are standard settings that may be modified
using the Selections and Options.
The last cycle that is set, including selections and options, is
saved even if the control is turned off.
Heavy Duty
Use for sturdy items, like play or work clothes, heavily soiled
jeans, T-shirts, etc. The wash time selection will depend on the
type of fabric and the amount of soil. For the best results when
cleaning heavily soiled items, use a higher soil level selection.
Lightly soiled items require less wash time.
Perm Press
Use for permanent press items and synthetics. The final spin
is a medium spin speed.
Normal Eco
This cycle uses a spray rinse to reduce water consumption. It
also uses less hot water. This cycle is recommended for wash-
ing everyday cottons and linens. If using fabric softener in this
cycle, select the Extra Rinse option.
Delicate
Wash items with delicate and/or gentle on the garment tag in
this cycle. Due to this cycle's uniquely designed motion, stiff
jeans and throw rugs also wash well in this cycle.
This cycle is designed to gently move items through the water
so it fills to a higher water level. It also has a low speed final
spin.
11
Control Panel
Part No. 204949EN