22.
Remove the display hinge (2). The display hinge is available in the Display Hinge Kit, spare part
number 513477-001 (16-inch display) or 519209-001 (15.6-inch display).
NOTE:
Steps 23 through 33 provide display assembly internal component removal information
for computer models equipped with BrightView display assemblies. See steps 5 through 22 for
display assembly internal component removal information for computer models equipped with
AntiGlare display assemblies.
NOTE:
See
Webcam/microphone moduleon page 60
replacement instructions for computer models equipped with BrightView display assemblies.
23.
If it is necessary to replace the display bezel or any of the display assembly internal components,
remove the following screw covers and screws: Two rubber screw covers on the display bezel
bottom edge (1). Two Phillips PM2.5×6.5 screws (2). The display rubber screw covers are included
in the Display Rubber Kit, spare part number 512361-001.
24.
Flex the inside edges of the top edge (1), the left and right sides (2), and the bottom edge (3) of
the display bezel until the bezel disengages from the display enclosure.
for webcam/microphone module
Component replacement procedures
87