HP Pavilion DV6-1030 Maintenance And Service Manual page 91

4. Remove the display assembly (2).
NOTE: Steps 5 through 22 provide display assembly internal component removal information for
computer models equipped with AntiGlare display assemblies. See steps 23 through 33 for display
assembly internal component removal information for computer models equipped with BrightView
display assemblies.
NOTE: See Webcam/microphone moduleon page 60
replacement instructions for computer models equipped with BrightView display assemblies.
5. If it is necessary to replace the display enclosure or any of the display assembly internal
components, remove the following screw covers and screws:
a. (1) Four rubber screw covers on the display bezel bottom edge. The display rubber screw
covers are included in the Display Rubber Kit, spare part number 513479-001 (15.6-inch
displays) or 512361-001 (16.0-inch displays).
b. (2) Four Phillips PM2.5×5.0 screws.
6. Turn the display assembly upside down, with the bottom edge toward you.
7. Release the display enclosure by sliding the enclosure (1) toward the top of the display assembly.
8. Lift the display enclosure (2) as far as the display logo cable allows.
for webcam/microphone module
Component replacement procedures 83