HP Mini 1000 Maintenance And Service Manual page 67

CAUTION: Support the display assembly when removing the following screws. Failure to support the
display assembly can result in damage to the display assembly and other device components.
1. Remove the three remaining Phillips PM2.5×5.0 screws (1) that secure the display assembly to
the device, and then remove the display assembly (2).
2. If it is necessary to replace the speaker assembly, perform the following steps:
a. Squeeze the sides of the speaker grill together to release the pressure clips, and then remove
the speaker grill. The speaker grill is available using spare part number 506338-001.
b. Remove the two Phillips PM2.0×4.5 screws (1) that secure the speaker assembly to the
display enclosure. All display assembly subcomponent screws are available in the Display
Screw Kit, spare part number 509700-001 for all 8.9-inch panels.
Component replacement procedures 59