HP Mini 1000 Maintenance And Service Manual page 46

4. Remove the two Phillips PM2.0×4.5 screws (3) that secure the hard drive to the device. Then lift
the drive (4) up, and slide it out of the drive bay.
Reverse this procedure to install the hard drive.
To remove the solid-state drive:
1. Release the ZIF connector (1) to which the USB board pass-through cable (that lies across the top
of the drive) is attached.
2. Disconnect the USB board pass-through cable (2), and then detach the tape from the top of the
drive.
3. Release the LIF connector (1) to which the solid-state drive cable is attached, and then disconnect
the cable (2).
38 Chapter 4 Removal and replacement procedures