Recovering The Factory Software - HP Compaq Evo N1010v Series Service Manual

Recovering the Factory Software

The following procedure describes how to recover the notebook's original operating system and
drivers. This process can take up to 15 minutes to complete. (For more information about recovering
the factory software installation, see the readme.txt file in the root directory of the Recovery CDs.)
CAUTION: Do not interrupt the following process or unplug the AC adapter until the process
completes.
1. Connect the AC adapter to the notebook.
2. Insert the Restore CD (or the Operating System) disk 1 into the notebook's CD/DVD drive. If the
notebook is turned off, use a pin or straightened paper clip to press the release switch on the drive
door to open it.
3. Turn on or restart the notebook.
4. When the HP logo appears, press
5. Use the arrow keys to select the CD/DVD drive as the first boot device, and then press
6. When the dialog box appears, follow the displayed instructions. If prompted, accept the
recommended partition size.
To create the Utility partition without installing the factory software, select Advanced, and then
select not to install the operating system.
If the hard disk is partitioned into several logical drives, you can install the factory software on
drive C without affecting other drives. select Advanced and then select to restore only the C partition.
7. When prompted to reboot the notebook, press
8. When the operating system has been installed and while Windows is running, replace the
OS CD with the Driver Recovery CD. If autorun is not enabled, select Start > Run. Then type
D:\SWSETUP\APPINSTL\SETUP.EXE
9. Follow the on-screen instructions for installing the drivers.
10. After the drivers have been installed, the application software may be installed.
Service Manual
to display the Boot menu.
esc
ctrl+alt+del,
(assuming " D :" is your drive designation), and then press
and then follow any instructions that appear.
Removal and Replacement
enter.
enter.
2-11