Page 1
Tools required for assembly and service may not be included. For technical questions or replacement parts, please call 1-800-444-3353. 66891 ® . All rights reserved. No portion of this manual or any artwork...
SKU 66891 For technical questions, please call 1-800-444-3353. notiCe is used to address practices not related to personal injury. Caution, without...
Page 4
A moment of inattention while operating power tools may result in serious personal injury. SKU 66891 For technical questions, please call 1-800-444-3353. use personal protective equip- ment. always wear anSi-approved safety eye protection and a dust- mask/respirator.
Page 5
The correct power tool will do the job better and safer at the rate for which it was designed. SKU 66891 For technical questions, please call 1-800-444-3353. do not use this Compact Belt Sander if the switch does not turn it on and off.
[to the State of California] to cause cancer, birth defects or other reproductive harm. SKU 66891 For technical questions, please call 1-800-444-3353. Some examples of these chemicals are: • Lead from lead-based paints •...
SaVe tHeSe inStruCtionS. SKU 66891 For technical questions, please call 1-800-444-3353. grounding to preVent eleCtriC SHoCk and deatH From inCorreCt grounding...
(See table a.) If you are using an extension cord outdoors, make sure it is marked with SKU 66891 For technical questions, please call 1-800-444-3353. the suffix “W-A” (“W” in Canada) to indicate it is acceptable for outdoor use.
SaFetY inFormation section at the beginning of this manual including all text under subheadings therein before set up or use of this product. SKU 66891 For technical questions, please call 1-800-444-3353. to preVent SeriouS injurY From aCCidental operation:...
Page 10
Wheel rotation. (Wheel rotation would be clockwise when you are looking into the open side of the Belt Sander). SKU 66891 For technical questions, please call 1-800-444-3353. warning! Severe laceration hazard! If a directional sanding belt (one...
Replace the worn/old Drive Belt (2) with a fresh/new Drive Belt (Part Number HTD 180-3M), and re-insert the two Wheels. SKU 66891 For technical questions, please call 1-800-444-3353. Tighten the Screws holding both Wheels in place Rotate the Belt Release Lever (35) “DOWN”...
To prevent accidents, turn off the Compact Belt Sander and disconnect its power supply after use. Clean, then store the tool indoors out of the reach of children. SKU 66891 For technical questions, please call 1-800-444-3353. maintenanCe and SerViCing Procedures not specifically...
If product has no serial number, record month and year of purchase instead. note: Some parts are listed and shown for illustration purposes only, and are not avail- able individually as replacement parts. SKU 66891 For technical questions, please call 1-800-444-3353. troubleshooting Check that cord is plugged in.
ASSUMES ALL RISk AND LIABILIty ARISINg OUt OF HIS OR HER REPAIRS tO tHE ORIgINAL PRODUCt OR REPLACEMENt PARtS tHEREtO, OR ARISINg OUt OF HIS OR HER INStALLAtION OF REPLACEMENt PARtS tHEREtO. SKU 66891 For technical questions, please call 1-800-444-3353. partS liSt Qty.