Display Assembly - HP Compaq Presario,Presario F500 Maintenance And Service Manual

Display assembly

Description
15.4-inch, WXGA, BrightView display assembly (includes wireless antenna transceivers
and cables)
Before removing the display assembly, follow these steps:
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
1.
computer on, and then shut it down through the operating system.
Disconnect all external devices connected to the computer.
2.
Disconnect the power cord.
3.
Remove the battery (see
4.
Remove the memory module compartment cover (see
5.
Disconnect the wireless antenna cables from the WLAN module (see
6.
Remove the following components:
7.
Switch cover (see
a.
Keyboard (see
b.
Remove the display assembly:
Disconnect the display cable (1) from the system board.
1.
Remove the wireless antenna cables (2) from the clips built into the top cover.
2.
CAUTION:
the display assembly can result in damage to the display assembly and other computer components.
Remove the four Phillips PM2.5×7.0 screws (1) that secure the display assembly to the computer.
3.
44 Chapter 4 Removal and replacement procedures
Battery on page
Switch cover on page
Keyboard on page
Support the display assembly when removing the following screws. Failure to support
29).
Memory module on page
38)
40)
Spare part number
444896–002
32).
WLAN module on page 35).