If it is necessary to replace the display bezel or the display assembly internal components, remove
10.
the six rubber screw covers (1) and the six Torx T8M2.5×6.0 screws (2) that secure the display
bezel to the display enclosure.
NOTE:
Flex the inside edges of the left and right sides (1) and the top and bottom sides (2) of the display
11.
bezel until the bezel disengages from the display enclosure.
Remove the display bezel (3). The display bezel is available using spare part number
12.
454399-001.
If it is necessary to replace the display inverter, release the inverter (1) as far as the display panel
13.
cable and backlight cable allow.
56
Chapter 4 Removal and replacement procedures
See
Camera module on page 38
for camera module removal information.