HP Compaq Presario,Presario 80XL201 User Manual page 43

Hard Disk Power Down After
The "Hard Disk Power Down After" item sets the time-out period for
the hard disk to power down if it is not in use during the set period.
The hard disk will power up again when next accessed.
The available options are Disabled, 1 Min, 2 Min, 4 Min, 8 Min, 10
Min, 15 Min, and 20 Min.
Standby After
The "Standby After" item sets the time-out period for initiating
Standby mode. It works in conjunction with the previous item "Idle
Mode." After the notebook enters Idle mode, the Power Saving starts
the time-out for the Standby mode. If the notebook remains in Idle
mode until the time-out period for Standby mode has been reached,
the notebook enters Standby mode.
If Standby mode is in effect, several system subsystems go into
standby or off mode so that system power will be reduced. The
system will wake up from Standby mode when system activity is
detected.
The available options are Disabled, 1 Min, 2 Min, 4 Min, 6 Min, 8 Min,
12 Min, and 16 Min.
Suspend After
The "Suspend After" item sets the time-out period for initiating
Suspend mode. It works in conjunction with the previous item
"Standby After." After the notebook enters Standby mode, the Power
Saving starts the time-out for the Suspend mode. If the notebook
remains in Standby mode until the time-out period for Suspend mode
has been reached, the notebook enters Suspend mode.
The Suspend mode is determined by the next item, "Suspend Data
to." It can be either Suspend-to-RAM or Suspend-to-File.
When Suspend-to-RAM mode is initiated, several system
subsystems go into standby or off mode so that system power will be
reduced further. The system will wake up from Suspend-to-RAM
mode when a key is pressed. "Resume On Time" and "Resume On
Modem Ring", if enabled in this submenu, can also wake up the
system from Suspend-to-RAM mode.
When Suspend-to-File mode is initiated, the system preserves all the
running application programs as a file in a "suspend-to-file partition"
on the hard disk and then turns off automatically.
The available options are Disabled, 1 Min, 2 Min, 5 Min, 10 Min, and
15 Min.
Suspend Data to
The "Suspend Data to" item defines the Suspend mode of your
system.
My Presario – Getting Started Setup Configuration Utility 5-9