To Use An External Monitor - HP Compaq Presario,Presario 2100 Reference Manual

To use an external monitor

Connecting an external monitor
1. Select Start > Turn Off Computer > Turn Off.
2. Connect the monitor cable from the monitor to the monitor port on the back of
the notebook.
3. Connect the monitor to a power source and turn it on.
4. Press the power button to turn on the notebook.
Switching the display to the external monitor
Press Fn+F5 to cycle through the display options: notebook display, external
monitor, both.
If you need to use both displays at once, press Fn+F5 repeatedly until the image
shows on both displays. With the default display settings, the external monitor
uses the same settings as the internal display. The external monitor displays the
same image as the internal display, regardless of the screen area, colors, and
other settings, and the refresh rate is the same for as the internal display (60 Hz).
If you use only the external monitor, you can select different settings not limited
by the internal display.
Adjusting monitor resolution and other settings
1. Select Start > Control Panel > Appearance and Themes > Display.
2. On the Settings tab, adjust the Screen area. Other settings are also available.
If you need to increase the refresh rate on the external monitor, you can switch to
only the external monitor. An alternative is to make one display a "secondary"
display so you can select independent refresh rates:
1. Select Start > Control Panel > Appearance and Themes > Display.
2. On the Settings tab, select the Advanced button, and then the Displays or Monitor
tab. Set the refresh rate on the Monitor tab.
Add-On Devices
Connecting External Devices
Reference Guide 51